價格：免費
更新日期：2019-04-12
檔案大小：13M
目前版本：2.1
版本需求：Android 4.0 以上版本
官方網站：http://www.innovateengineering.pro/gearhead
Email：support@innovateengineering.pro
聯絡地址：116 N 3RD ST STE 529 PALMYRA, WI 53156-9347
If you are a hobby gearhead or professional engine or chassis builder, you’ll want Gearhead Offroad! Gearhead Offroad is the calculator app that us gearheads use for many performance automotive parameters. It calculates or estimates numerous engine, exhaust, gearing, tire, suspension, acceleration, and other vehicle parameters along with tap and drill sizes. Gearhead Pro works in both standard and metric units and even has advanced settings to customize the calculations to your specific scenario so you can select the most compatible parts for your application.
Gearhead Offroad calculates or estimates:
Speed/Gearing
- Engine RPM from vehicle speed, gearing, tire size
- Vehicle Speed from engine RPM, gearing, tire size
- Axle Gear needed for a specific RPM at a certain speed with a given tire size
- Tire Diameter and Cross section width from sidewall size
- Simple gear ratios based on drive and driven tooth count
Engine
- Displacement from cylinders, bore, and stroke
- Bore/Stroke ratio
- Static Compression Ratio
- Average Piston Speed
- Airflow
- Connecting Rod Ratio
- Maximum connecting rod angle from cylinder axis
- Compression Height (piston wrist pin height)
- Dynamic Compression Ratio from the point the intake valve closes
- Head gasket volume (from bore and compressed thickness if round)
- Valve opening and closing events from the cam duration, IC, and LSA
- Cam specs from the valve opening and closing events
- Valve overlap
- Valve lift based on new rocker ratio or lobe lift and rocker ratio
- Valve spring forces from valve spring specs to actual installed height and lift
- Mark dimension on your balancer to set a desired timing advance
Engine Externals
- Minimum air filter size for your engine
- Recommended header primary tube size for your engine
- Recommended exhaust size for your engine
- Cross-sectional flow area of a pipe, or the pipe size from a desired flow area
Suspension
- Instant center, Roll Center and Axis, and Anti-Squat of a 4-link rear suspension
- Cg height of your vehicle using the raise one end method
- Combined and secondary spring rates of a dual spring coil-over setup
Power
- Power from Torque and RPM, or vice versa
Fasteners and Threading
- Lookup cutting tap drill size
Fuel System
- Total Fuel system flow for fuel pump selection
- Fuel injector flow for injector selection
- Convert an injector flow rating to a new pressure or flow
If you are looking for more please check out our "Gearhead Pro" app.
None of our apps have adds or use special permissions.
